Škoda Octavia Workshop (S00.5117.50.20 Edition 08.96) Manual Electrical System



Škoda Octavia Workshop (S00.5117.50.20 Edition 08.96) Manual Electrical System PDF

Škoda Octavia Workshop (S00.5117.50.20 Edition 08.96) Manual Electrical System PDF  Free Download.

CONTENTS:

Starter, Power supply

  • Battery
  • – Battery handling instructions
  • – Inspecting electrolyte level
  • – Measuring voltage under load
  • – Testing electrolyte density
  • – Charging battery
  • – Quick charger/starting aid
  • – Removing and installing battery
  • – Battery with magic eye
  • – Topping up electrolyte level
  • Removing and installing generator
  • – Vehicles with petrol engine
  • – Vehicles with diesel engine
  • – Removing and installing belt pulley of AC generator
  • Removing and installing starter

Gauges, Instruments

  • Dash panel insert ( > MY 00)
  • – Self-diagnosis
  • – Initiating self-diagnosis of the dash panel insert
  • – Interrogating fault memory
  • – Fault table
  • – Actuator diagnosis
  • – Erasing fault memory
  • – Ending output
  • – Coding control unit
  • – Reading measured value block
  • – Adaptation
  • – Adapting service interval display
  • – Input values when replacing the dash panel insert
  • – Resetting SID after service without V.A.G 1552/1551
  • – Resetting SID after service with V.A.G 1552/1551
  • – Removing and installing dash panel insert
  • – Bulb assignment on the dash panel insert
  • – Contact assignment of plug connections on the dash panel insert
  • – Testing signal of fuel gauge sender -G-
  • – Contact assignment at fuel gauge sender -G-
  • – Testing coolant temperature sender
  • – Testing speed signal
  • Taximeter and Printer
  • – Removing and installing taximeter HALE
  • – Removing and installing printer HALE
  • Dash panel insert (MY 01 >)
  • – Self-diagnosis
  • – Initiating self-diagnosis of the dash panel insert
  • – Interrogating fault memory
  • – Fault table
  • – Actuator diagnosis
  • – Erasing fault memory
  • – Ending output
  • – Coding dash panel insert
  • – Reading measured value block
  • – Adaptation
  • – Adapting service interval data when replacing the dash panel insert
  • – Input values when replacing the dash panel insert
  • Self-diagnosis of the Gateway
  • – Initiating self-diagnosis
  • – Interrogating fault memory
  • – Fault table
  • – Erasing fault memory
  • – Ending output
  • – Coding control unit
  • – Reading measured value block
  • – Removing and installing dash panel insert
  • – Contact assignment of plug connections on the dash panel insert
  • – Testing signal of fuel gauge sender -G-
  • – Testing contact assignment of fuel gauge sender -G-
  • – Testing coolant temperature sender
  • – Testing speed signal
  • – Testing output temperature sender -G17-
  • – Testing oil level/oil temperature sender -G266-
  • CAN databus
  • – Testing CAN databus drive
  • – Testing terminating resistances of the control units
  • – Testing CAN databus for short circuit
  • – Testing CAN databus convenience

Radio, Two-Way Radio, Mobile Phone

  • Radio systems
  • – General notes
  • – Radio system with 4 loudspeakers
  • – Radio system with 8 loudspeakers
  • – Overview of radio systems
  • – Removing and installing radio
  • – Removing and installing loudspeaker
  • – Removing and installing radio “Gamma (MS 501), MS 303, Symphony”
  • Removing and installing roof antenna
  • Telephone systems
  • – Overview of telephone systems
  • – Telephone preinstallation 1
  • – Telephone preinstallation 2 – Cullmann
  • – Telephone system
  • Removing and installing telephone operating electronics control unit -J412-(interface box)
  • Overview of holder for mobile phone 1
  • Overview of holder for mobile phone 2
  • Removing and installing telephone microphone -R38- > 08.00
  • Removing and installing telephone microphone -R38- 09.00 >
  • Self-diagnosis of radio system “Gamma (MS 501), MS 303 and Symphony”
  • – Connect vehicle system tester V.A.G 1552 and select radio control unit
  • – Interrogating and erasing fault memory
  • – Fault table
  • – Actuator diagnosis
  • – Coding radio
  • – Reading measured value block
  • Removing and installing CD changer
  • Radio-Navigation system (RNS)
  • – General description.
  • – Self-diagnosis of radio unit in RNS
  • – Self-diagnosis of navigation unit in RNS
  • – Interrogating and erasing fault memory
  • – Fault table
  • – Actuator diagnosis
  • – Reading measured value block
  • – Adaptation
  • – Coding RNS control unit
  • – Electronic anti-theft lock
  • – Plug connections at Radio-Navigation System
  • – Removing and installing Radio-Navigation System
  • Multi-function steering wheel
  • – General description
  • – Interrogating and erasing fault memory
  • – Fault table
  • – Coding multi-function steering wheel control unit -J453-
  • – Actuator diagnosis
  • – Reading measured value block
  • – Removing and installing pressure unit for multi-function steering wheel
  • – Contact assignment of 18-pin connector for multi-function steering wheel CU -J453-

Windscreen wiper and washer system

  • Windscreen wiper system
  • – Removing and installing windscreen wiper system
  • – Setting park position of windscreen wiper blades
  • Servicing windscreen washer system
  • – Removing and installing windshield washer fluid reservoir
  • – Removing and installing spray nozzles
  • – Adjusting spray nozzles
  • Servicing headlamp cleaning system
  • – Removing and installing spray nozzles of headlamp cleaning system
  • – Adjusting spray nozzles
  • – Removing and installing windshield washer fluid reservoir
  • Rear window wiper and washer system
  • – Rear window wiper system – Summary of components
  • – Removing and installing rear window wiper
  • – Setting park position of rear window wiper
  • – Adjusting spray nozzle
  • – Replacing spray nozzle (Octavia Estate)
  • – Replacing spray nozzle (Octavia)
  • – Removing and installing wiper rubber
  • – Removing and installing rain sensor

Exterior Lights, Bulbs and Switches

  • Servicing headlights
  • – Overview >- 07.00
  • – Overview 08.00 >-
  • – Removing and installing headlights
  • – Setting headlights
  • – Replacing bulbs at headlights
  • – Removing and installing headlight range control motor
  • Servicing turn signal lights
  • – Removing and installing turn signal lights
  • – Removing and installing bulb for turn signal light
  • – Removing and installing side turn signal lights
  • Servicing rear lights
  • – Overview
  • – Removing and installing bulbs from lamp holder
  • – Removing and installing rear light
  • Removing and installing licence plate illumination
  • Servicing steering column switch
  • – Removing and installing steering column switch
  • – Contact assignment at steering column switch – until MY 98
  • – Contact assignment at steering column switch – as of MY 99
  • Servicing lock cylinder and ignition starter switch
  • – Removing and installing lock cylinder
  • – Removing and installing ignition starter switch
  • – Contact assignment at ignition starter switch
  • Removing and installing rear lights of Octavia Estate
  • Additional brake light
  • – Additional brake light for Octavia
  • – Additional brake light for Octavia Estate
  • Anti-theft alarm system
  • – Contact switch for anti-theft alarm system F120 (engine hood)
  • – Horn for anti-theft alarm system H8
  • – Alarm system with its own power supply H12
  • – Replacing emergency battery for alarm system
  • Overview of parking aid
  • – Removing and installing parking aid control unit -J446-
  • – Removing and installing parking aid warning buzzer -H15-
  • – Removing and installing parking aid sender
  • Self-diagnosis of parking aid (parking system)
  • – General notes
  • – Initiating self-diagnosis of parking aid
  • – Interrogating and erasing fault memory
  • – Fault table
  • – Coding control unit
  • – Reading measured value block
  • – Adaptation
  • Roof sign „TAXI“
  • – Removing and installing bracket of roof sign „Taxi“
  • Self-diagnosis for xenon headlight with automatic regulation (system Litronic 4.1)
  • – Interrogating fault memory
  • – Fault table
  • – Actuator diagnosis
  • – Initiating basic setting
  • – Erasing fault memory
  • – Ending output
  • – Coding control unit
  • – Reading measured value block
  • Xenon headlight with automatic regulation (system Litronic 4.1) -overview
  • – Headlight with control unit
  • – Removing and installing front xenon headlight
  • – Replacing bulbs in headlights
  • – Removing and installing discharge lamp D2S
  • – Removing and installing ignition/high voltage unit BOSCH 2.3
  • – Removing and installing step motor
  • – Removing and installing front sender
  • – Removing and installing rear sender
  • – Removing and installing control unit
  • – Sender adjusting options
  • – Contact assignment of Xenon headlights
  • – Switch-over of the headlight inner aperture
  • – Ungluing a halogen headlight

Interior Lights, Bulbs and Switches – Anti-theft lock

  • Diagnosis of electronic immobiliser
  • – Self-diagnosis of 1st generation immobiliser
  • – Initiating self-diagnosis of immobiliser
  • – Interrogating control unit version
  • – Interrogating fault memory
  • Fault table for the immobiliser
  • – Erasing fault memory
  • – Ending output
  • – Reading measured value block
  • – Adaptation
  • – Adaptation of car key
  • – Procedure in case the key is lost
  • – Adaptation after replacing the engine control unit
  • – Adaptation after replacing the immobiliser control unit
  • – Emergency start function with V.A.G 1552
  • – Emergency start function without V.A.G 1552
  • – Defective transponder and/ or key is lost
  • – Replacing reading coil
  • – Procedure when replacing the lock set or the immobilizer control unit
  • – System test
  • Servicing switches
  • – Removing and installing switches in centre console
  • – Removing and installing light switch
  • – Removing and installing adjuster for headlamp range control
  • – Removing and installing door contact switch
  • – Removing and installing switch for sun roof and interior light
  • – Removing and installing mirror adjustment switch
  • – Removing and installing window lifter switch
  • Servicing interior lights
  • – Removing and installing glove box light
  • – Removing and installing rear reading lights
  • – Removing and installing ashtray illumination
  • – Removing and installing make-up mirror lamp
  • – Removing and installing door warning lamp
  • – Removing and installing warning lamp for deactivated airbag
  • Servicing horn
  • – Removing and installing horn
  • Removing and installing luggage compartment lights
  • Removing and installing switch for remote release/fuel tank lid
  • Removing and installing luggage compartment power socket

Language: English
Format: PDF
Pages: 308
Size: 9.47 Mb
Free download Škoda Octavia Workshop (S00.5117.50.20 Edition 08.96) Manual Electrical System PDF
Password: cardiagn.com
https://cloud.mail.ru/public/M6R8/EakvRGua5